4,4''-DIAMINO-P-TERPHENYL

4,4''-DIAMINO-P-TERPHENYL Property

Melting point:

242-244°C

Boiling point:

484.2±25.0 °C(Predicted)

Density 

1.159±0.06 g/cm3(Predicted)

storage temp. 

Keep in dark place,Inert atmosphere,Room temperature

solubility 

soluble in Tetrahydrofuran,Acetone

pka

4.59±0.10(Predicted)

Appearance

White to light yellow Solid

BRN 

2120295

InChI

InChI=1S/C18H16N2/c19-17-9-5-15(6-10-17)13-1-2-14(4-3-13)16-7-11-18(20)12-8-16/h1-12H,19-20H2

InChIKey

QBSMHWVGUPQNJJ-UHFFFAOYSA-N

SMILES

C1(C2=CC=C(C3=CC=C(N)C=C3)C=C2)=CC=C(N)C=C1

Safety

Risk Statements 

20/21/22-45

Safety Statements 

45-53

RIDADR 

2811

PackingGroup 

II

HS Code 

29215900

Hazard and Precautionary Statements (GHS)

Symbol(GHS)

Signal word

Danger

Hazard statements

H302Harmful if swallowed

H341Suspected of causing genetic defects

H350May cause cancer

Precautionary statements

P201Obtain special instructions before use.

P202Do not handle until all safety precautions have been read and understood.

P261Avoid breathing dust/fume/gas/mist/vapours/spray.

P264Wash hands thoroughly after handling.

P264Wash skin thouroughly after handling.

P270Do not eat, drink or smoke when using this product.

P271Use only outdoors or in a well-ventilated area.

P280Wear protective gloves/protective clothing/eye protection/face protection.

P308+P313IF exposed or concerned: Get medical advice/attention.

P405Store locked up.

P501Dispose of contents/container to..…

4,4''-DIAMINO-P-TERPHENYL Chemical Properties,Usage,Production

Uses

4,4''-Diamino-p-terphenyl can be used to make selective hydrogen sensors that have high sensitivity, low consumption, and no cross-sensitivity to methane and ethane even at their operating temperatures and higher. Moreover, it is also used for studies of Symmetry breakdown of 4,4″-diamino-p-terphenyl on a Cu(111) surface by lattice mismatch^[1-2].

Synthesis

1,4-dibromobenzene (0.980 g, 4.15 mmol) and pinacol ester of 4-aminobenzeneboronic acid (2.0 g, 9.13 mmol) were catalyzed by Pd(PPh3)4 (0.3 g, 0.415 mmol) with the addition of K2CO3 (8.6 g, 62.3 mmol), water (10 mL) and toluene (10 mL) in a 50 mL Schlenk flask equipped with a magnetic stirrer. The mixture was rapidly frozen by liquid nitrogen, evacuated to 50 mT, and thawed under static vacuum; this freeze-evacuate-thaw cycle was repeated three times. Subsequently, the flask was backfilled with N2 and a water-cooled condenser, red septum and bubbler were attached to maintain a positive N2 flow under N2 atmosphere. The reaction mixture was heated to 120 °C under N2 protection for 24 h. The progress of the reaction was monitored by TLC. Upon completion of the reaction, it was cooled to room temperature, quenched with water (5 mL) and extracted with EtOAc (3 x 10 mL). The organic phases were combined, washed sequentially with water (3 × 10 mL) and brine (3 × 10 mL), dried over anhydrous Na2SO4 and filtered through diatomaceous earth. The solvent was concentrated under reduced pressure, rotary evaporated at 40 °C, and subsequently purified by silica gel column chromatography (eluent: 35% EtOAc in hexane solution) to afford the white solid product 4,4'-diaminotriphenylene in a yield of 0.560 g (52%). The product was analyzed by 1H NMR (400 MHz, DMSO-d6) δ 7.53 (s, 1H), 7.39-7.35 (d, 1H), 6.66-6.62 (d, 1H), 5.20 (s, 1H); 13C NMR (100 MHz, DMSO) δ 148.18, 137.93, 127.11, 126.82, 125.55, 114.22, 99.51, 39.52; HRMS (ESI-TOF) m/z calculated value C18H16N2 [M+H]+: 261.1393, measured value 261.1355.

References

[1] A. S. PRANTI. Highly Sensitive and Selective Hydrogen Gas Sensor with Platinum Nanoparticles Linked by 4,4"-Diamino-P-Terphenyl (Dater)[J]. 2019 20th International Conference on Solid-State Sensors, Actuators and Microsystems & Eurosensors XXXIII (TRANSDUCERS & EUROSENSORS XXXIII), 2019. DOI:10.1109/TRANSDUCERS.2019.8808479.
[2] QIGANG ZHONG. Symmetry breakdown of 4,4″-diamino-p-terphenyl on a Cu(111) surface by lattice mismatch.[J]. Nature Communications, 2018. DOI:10.1038/s41467-018-05719-y.