2-(TRIMETHYLSILYL)ETHANESULFONYL CHLORI& Property

Boiling point:

146.8 °C/760 mmHg

Density 

1.059 g/mL at 25 °C

refractive index 

n20/D 1.4444

Flash point:

21 °C

storage temp. 

2-8°C

solubility 

Sol most common organic solvents.

Safety

Hazard Codes 

F,Xi

Risk Statements 

11-36/37/38

Safety Statements 

26

RIDADR 

UN 1993 3/PG 2

WGK Germany 

3

HS Code 

2931900090

Hazard and Precautionary Statements (GHS)

Symbol(GHS)

Signal word

Danger

Hazard statements

H225Highly Flammable liquid and vapour

H315Causes skin irritation

H319Causes serious eye irritation

H335May cause respiratory irritation

Precautionary statements

P210Keep away from heat/sparks/open flames/hot surfaces. — No smoking.

P302+P352IF ON SKIN: wash with plenty of soap and water.

P305+P351+P338IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continuerinsing.

2-(TRIMETHYLSILYL)ETHANESULFONYL CHLORI& Chemical Properties,Usage,Production

Physical properties

bp 60 °C/0.1 mmHg; yellow oil.

Uses

β-Trimethylsilylethanesulfonyl Chloride is used in the protection of primary and secondary amines as their sulfonamides, which are cleaved by fluoride ion. It participates in the reations of Protection of Amines, SESCl in Synthesis, N-Alkylation, Deprotection Conditions, Formation of 2-Trimethylsilylethanesulfonylimines, the (N-SES-Imino) Phenyliodinane or SESN=IPh Reagent, SES-N3, etc.

Uses

2-(Trimethylsilyl)ethanesulfonyl Chloride can be prepared to used to treat cancer and other diseases.

Preparation

|?-Trimethylsilylethanesulfonyl Chloride can be most conveniently synthesized from commercially available vinyltrimethylsilane (eq 1). Radical addition of sodium bisulfite to the vinyl group catalyzed by t-butyl perbenzoate yields the sulfonate salt which can be directly converted to SESCl with phosphorus(V) chloride. The chloride can then be purified by distillation. The intermediate sulfonate salt is commercially available. The chloride can also be prepared in 62% yield from the salt using sulfuryl chloride and triphenylphosphine (eq 2). A less convenient procedure to synthesize SESCl using |?-trimethylsilylethylmagnesium chloride and sulfuryl chloride has also been developed (eq 3).

Purification Methods

Check IR; if the bands at ~3200 (OH) cm-1 are strong, then much of the SES-Cl had hydrolysed, and it should be treated with POCl3 (with cooling) and stirred at ~25o for about 1hour, poured into ice cold H2O, extracted with CH2Cl2, washed with NaHCO3, dried (Na2SO4), evaporated , and it distils as a yellow oil in a vacuum. This procedure is used for converting the Na salt to SES-Cl. It reacts with amines to form amides, e.g. SES-NRR’, which on heating with CsF (i.e. F-ions) in DMF at 95o provide the amine (NHRR’), SO2 and CH2=CH2 [Weinreb et al. Tetrahedron Lett 27 2099 1986]. [Ribiere et al. Chem Rev 106 2249 2006.]