Amantocillin Usage And Synthesis

Originator

Amantocillin,Onbio Inc.

Manufacturing Process

A mixture of 3-bromoadamantane-1-carboxylic acid (5.8 g), acetonitrile (45 ml) and concentrated sulphuric acid (9 ml) was refluxed for 20 h. After cooling, the mixture was poured into water (250 ml), and the resulting suspension concentrated in vacuo to remove most of the acetonitrile. Aqueous sodium hydroxide (33%) was added until the pH was 4.0 (about 24 ml). The precipitate was filtered off, washed with water, and dried to yield 4.4 g of the 3-acetaminoadamantane-1-carboxylic acid, melting point 254°-258°C (two recrystallizations from methanol-aceto nitrile).
A solution of 3-acetamino-adamantane-1-carboxylic acid (3.0 g) in 4 N sodium hydroxide (40 ml) was refluxed for 5 h. After cooling, the pH of the solution was adjusted to 7 with acetic acid. The crystalline precipitate was filtered off, washed with ethanol and dried to yield 2.20 g of the desired compound, melting point over 330°C. In order to purify the compound, 2.0 g of it was suspended in water (10 ml), 4 N NaOH (2 ml) was added, and the resulting solution filtered through a filter aid known under the registered trademark 'Dicalite'. The filtrate was adjusted to a pH of 6.5 with acetic acid. The resulting crystalline precipitate was filtered off, washed with a little water followed by alcohol, and dried to yield 1.55 g of pure 3-amino-adamantane-1- carboxylic acid.
3-Aminoadamantane-1-carboxylic acid (1.0 g) was refluxed with thionyl chloride (4.6 ml) for 1 h. Excess of thionyl chloride was removed in vacuo. The residue was dissolved in benzene (3 ml), and the resulting solution evaporated under reduced pressure to remove traces of thionyl chloride. This process was repeated to leave 1.3 g of a 3-thionyliminoadamantane-1- carboxylic acid chloride, almost colourless.
500.0 mg of 3-thionyliminoadamantane-1-carboxylic acid chloride were dissolved in dry acetone (8 ml), and the resulting solution was added during 20 min at room temperature with stirring, to a suspension of 6- aminopenicillanic acid (520.0 mg) in 50% aqueous acetone (20 ml), previously adjusted to a pH of 7.0 with triethylamine. During the process, a pH value of 7.0 was maintained by the addition of a 1 N solution of triethylamine in 50% aqueous acetone from an automatic titrator. At the end of the reaction, a clear solution was obtained. Acetone was removed in vacuo, and 70% of the theoretical amount of 3-amino-adamantyl-1-penicillin was formed.
The aqueous solution was concentrated in vacuo to a volume of 4 ml. Addition of acetone (40 ml) gave an oily precipitate which after decanting and addition of fresh acetone gave 900.0 mg of a semicrystalline solid which contained 50% of the theoretical amount of 3-aminoadamantyl-1-penicillin.

Therapeutic Function

Antibiotic

Amantocillin(10004-67-8)Related Product Information

• VALROCEMIDE
• Amantocillin
• penicillin K