Product Identification

Product Name

4-Chloro-1,3-phenylenediamine

Synonyms

3-Amino-4-chloroaniline
4-Chloro-1,3-benzenediamine
4-Chlorobenzene-1,3-diamine
4-Chloro-m-phenylenediamine
C.I. 76027

CAS

5131-60-2

Formula

C6H7ClN2

Molecular Weight

142.6

EINECS

225-877-9

RTECS

SS8800000

RTECS Class

Tumorigen; Mutagen

Beilstein/Gmelin

2081090

Beilstein Reference

4-13-00-00096

Physical and Chemical Properties

Appearance

Gray powder or dark purple solid.

Solubility in water

Soluble

Melting Point

91

Boiling Point

280

pKa/pKb

10.03 (pKb)

Partition Coefficient

.99

Usage

Chemical research.

First Aid Measures

Ingestion

DO NOT INDUCE VOMITING. If the victim is conscious and not convulsing, give 1 or 2 glasses of water to dilute the chemical and IMMEDIATELY call a hospital or poison control center. Be prepared to transport the victim to a hospital if advised by a physician. If the victim is convulsing or unconscious, do not give anything by mouth, ensure that the victim's airway is open and lay the victim on his/her side with the head lower than the body. DO NOT INDUCE VOMITING. IMMEDIATELY transport the victim to a hospital.

Inhalation

IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. IMMEDIATELY call a physician and be prepared to transport the victim to a hospital even if no symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used.

Skin

IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. IMMEDIATELY call a hospital or poison control center even if no symptoms (such as redness or irritation) develop. IMMEDIATELY transport the victim to a hospital for treatment after washing the affected areas.

Eyes

First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop.

Handling and Storage

Storage

Keep in a cool, dry, dark location in a tightly sealed container or cylinder. Keep away from incompatible materials, ignition sources and untrained individuals. Secure and label area. Protect containers/cylinders from physical damage.

Handling

All chemicals should be considered hazardous. Avoid direct physical contact. Use appropriate, approved safety equipment. Untrained individuals should not handle this chemical or its container. Handling should occur in a chemical fume hood.

Hazards Identification

Ingestion

Nausea and vomiting may occur.

Inhalation

Dyspnea and tachypnea may occur.

Skin

Central cyanosis unresponsive to oxygen therapy is classic.

Exposure Controls/Personal Protection

Personal Protection

If Tyvek-type disposable protective clothing is not worn during handling of this chemical, wear disposable Tyvek-type sleeves taped to your gloves.

Respirators

Wear a NIOSH-approved half face respirator equipped with a combination filter cartridge, i.e. organic vapor/acid gas/HEPA (specific for organic vapors, HCl, acid gas, SO2 and a high efficiency particulate filter).

Fire Fighting Measures

Fire Fighting

Fires involving this material can be controlled with a dry chemical, carbon dioxide or Halon extinguisher.

Fire Potential

This material is probably combustible.

Accidental Release Measures

Small spills/leaks

If you spill this chemical, FIRST REMOVE ALL SOURCES OF IGNITION. You should then dampen the solid spill material with 60-70% methanol, then transfer the dampened material to a suitable container. Use absorbent paper dampened with methanol to pick up any remaining material. Your contaminated clothing and absorbent paper should be sealed in a vapor-tight plastic bag for eventual disposal. Solvent-wash contaminated surfaces with 60-70% methanol followed by washing with a soap and water solution. Do not reenter the contaminated area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned.

Stability and Reactivity

Incompatibilities

Incompatible with isocyanates, halogenated organics, peroxides, phenols (acidic), epoxides, anhydrides, and acid halides Flammable gaseous hydrogen is generated in combination with strong reducing agents, such as hydrides.

Stability

No data.