Product Identification

Product Name

Phenyltriethoxysilane

Synonyms

LS 4480
Phenyltriethoxysilane
PTS 32
Tri(ethoxo)(phenyl)silane
TSL 8178

CAS

780-69-8

Formula

C12H20O3Si

Molecular Weight

240.38

EINECS

212-305-8

RTECS

VV4900000

RTECS Class

Primary Irritant

Beilstein/Gmelin

2940602

Beilstein Reference

4-16-00-01556

EC Class

flammable

Physical and Chemical Properties

Appearance

Clear, colorless liquid.

Solubility in water

Insoluble

Melting Point

41

Boiling Point

237

Vapor Pressure

0.07 (25 C)

Density

1.0133 g/cm3 (0 C)

Partition Coefficient

2.99

Heat Of Vaporization

45.4 kJ/mol

Heat Of Combustion

-7558 kJ/mol

Vapor Density

8.29

Refractive Index

1.4604 (20 C)

First Aid Measures

Ingestion

If victim is conscious and alert, give 2-4 cupfuls of milk or water. Never give anything by mouth to an unconscious person. Get medical aid. Get medical aid immediately. Do NOT induce vomiting. If conscious and alert, rinse mouth and drink 2-4 cupfuls of milk or water.

Inhalation

Remove from exposure to fresh air immediately. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. Get medical aid.

Skin

Get medical aid. Flush skin with plenty of soap and water for at least 15 minutes while removing contaminated clothing and shoes. Wash clothing before reuse.

Eyes

Immediately flush eyes with plenty of water for at least 15 minutes, occasionally lifting the upper and lower eyelids. Get medical aid.

Handling and Storage

Storage

Keep away from heat, sparks, and flame. Keep away from sources of ignition. Store in a tightly closed container. Store in a cool, dry, well-ventilated area away from incompatible substances. Flammables-area. Store protected from moisture.

Handling

Ground and bond containers when transferring material. Use spark-proof tools and explosion proof equipment. Avoid contact with eyes, skin, and clothing. Empty containers retain product residue, (liquid and/or vapor), and can be dangerous. Keep container tightly closed. Avoid contact with heat, sparks and flame. Avoid ingestion and inhalation. Use with adequate ventilation. Do not allow contact with water. Wash clothing before reuse. Do not pressurize, cut, weld, braze, solder, drill, grind, or expose empty containers to heat, sparks or open flames. Keep from contact with moist air and steam.

Hazards Identification

Inhalation

Causes respiratory tract irritation. Aspiration may lead to pulmonary edema. Vapors may cause dizziness or suffocation. Can produce delayed pulmonary edema. May cause burning sensation in the chest.

Skin

Causes skin irritation. May cause dermatitis. May cause cyanosis of the extremities.

Eyes

Causes eye irritation. May cause chemical conjunctivitis and corneal damage.

Ingestion

May cause gastrointestinal irritation with nausea, vomiting and diarrhea. Ingestion of large amounts may cause CNS depression.

Hazards

Vapors may form explosive mixtures with air. Vapors may travel to source of ignition and flash back. Most vapors are heavier than air. They will spread along ground and collect in low or confined areas (sewers, basements, tanks). Vapor explosion hazard indoors, outdoors or in sewers.

EC Risk Phrase

R 36/38

EC Safety Phrase

S 26 36

UN (DOT)

1993

Exposure Controls/Personal Protection

Personal Protection

Eyes: Wear appropriate protective eyeglasses or chemical safety goggles as described by OSHA's eye and face protection regulations in 29 CFR 1910.133 or European Standard EN166. Skin: Wear appropriate protective gloves to prevent skin exposure. Clothing: Wear appropriate protective clothing to prevent skin exposure.

Respirators

A respiratory protection program that meets OSHA's 29 CFR 1910.134 and ANSI Z88.2 requirements or European Standard EN 149 must be followed whenever workplace conditions warrant a respirator's use. Wear a NIOSH/MSHA or European Standard EN 149 approved full-facepiece airline respirator in the positive pressure mode with emergency escape provisions.

Exposure Effects

Effects may be delayed.

Fire Fighting Measures

Flash Point

103

Autoignition

265

Fire Fighting

Wear a self-contained breathing apparatus in pressure-demand, MSHA/NIOSH (approved or equivalent), and full protective gear. During a fire, irritating and highly toxic gases may be generated by thermal decomposition or combustion. Will burn if involved in a fire. Use water spray to keep fire-exposed containers cool. Containers may explode in the heat of a fire. Extinguishing media: For small fires, use dry chemical, carbon dioxide, water spray or alcohol-resistant foam. For large fires, use water spray, fog, or alcohol-resistant foam. Use water spray to cool fire-exposed containers. Water may be ineffective. Use agent most appropriate to extinguish fire. Do NOT get water inside containers. Do NOT use straight streams of water.

Fire Potential

HIGHLY FLAMMABLE: Will be easily ignited by heat, sparks or flames.

Accidental Release Measures

Small spills/leaks

Absorb spill with inert material, (e.g., dry sand or earth), then place into a chemical waste container. Clean up spills immediately, using the appropriate protective equipment. Remove all sources of ignition. Use a spark-proof tool. Provide ventilation. Do not get water inside containers. A vapor suppressing foam may be used to reduce vapors.

Stability and Reactivity

Incompatibilities

Moisture.

Stability

Stable at room temperature in closed containers under normal storage and handling conditions.

Decomposition

Carbon monoxide, irritating and toxic fumes and gases, carbon dioxide, silicon oxide.

Combustion Products

Fire may produce irritating, corrosive and/or toxic gases.

Transport Information

UN Number

1993

Hazard Class

3

Packing Group

I; II; III

HS Code

2931 00 95