Product Identification

Product Name

1,2-Bis(tetrabromophthalimido) ethane

Synonyms

1H-Isoindole-1,3(2H)-dione, 2,2'-(1,2-ethanediyl)bis(4,5,6,7-tetrabromo-
2,2'-(1,2-Ethanediyl)bis(4,5,6,7-tetrabromo-1H-isoindole-1,3(2H)-dione)
BT 93
BT 93D
BT 93W
Ethylene bis(tetrabromophthalimide)

CAS

32588-76-4

Formula

C18H4Br8N2O4

Molecular Weight

951.52

EINECS

251-118-6

RTECS

NR3398507

RTECS Class

Primary Irritant

Beilstein/Gmelin

1559294

Physical and Chemical Properties

Melting Point

465

Density

2.67 g/cm3 (20 C)

First Aid Measures

Ingestion

DO NOT INDUCE VOMITING. If the victim is conscious and not convulsing, give 1 or 2 glasses of water to dilute the chemical and IMMEDIATELY call a hospital or poison control center. Be prepared to transport the victim to a hospital if advised by a physician.

Inhalation

IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. If symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop, call a physician and be prepared to transport the victim to a hospital. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used.

Skin

IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. If symptoms such as redness or irritation develop, IMMEDIATELY call a physician and be prepared to transport the victim to a hospital for treatment.

Eyes

First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop.

Handling and Storage

Storage

Keep in a cool, dry, dark location in a tightly sealed container or cylinder. Keep away from incompatible materials, ignition sources and untrained individuals. Secure and label area. Protect containers/cylinders from physical damage.

Handling

All chemicals should be considered hazardous. Avoid direct physical contact. Use appropriate, approved safety equipment. Untrained individuals should not handle this chemical or its container. Handling should occur in a chemical fume hood.

Hazards Identification

Ingestion

See inhalation.

Inhalation

This compound may cause transient eye irritation.

Skin

See inhalation.

Eyes

See inhalation

Hazards

Flash point data for this compound are not available but it is probably non-flammable.

Exposure Controls/Personal Protection

Personal Protection

Chemical splash goggles in compliance with OSHA regulations are advised; however, OSHA regulations also permit other type safety glasses. Whre chemical resistant gloves. To prevent repeated or prolonged skin contact, wear impervious clothing and boots.

Respirators

Wear a NIOSH-approved half face respirator equipped with an organic vapor/acid gas cartridge (specific for organic vapors, HCl, acid gas and SO2) with a dust/mist filter.

Fire Fighting Measures

Fire Fighting

Fires involving this compound should be controlled using a dry chemical, carbon dioxide, foam or Halon extinguisher.

Accidental Release Measures

Small spills/leaks

You should dampen the solid spill material with acetone, then transfer the dampened material to a suitable container. Use absorbent paper dampened with acetone to pick up any remaining material. Seal your contaminated clothing and the adsorbent paper in a vapor-tight plastic bag for eventual disposal. Solvent wash all contaminated surfaces with acetone followed by washing with a strong soap and water solution. Do not reenter the contaminate area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned.

Stability and Reactivity

Incompatibilities

May react with strong oxidizers.

Stability

No data.