Product Identification

Product Name

2-Ethylbutyryl chloride

Synonyms

2-Ethylbutyryl chloride
Diethylacetyl chloride

CAS

2736-40-5

Formula

C6H11ClO

Molecular Weight

134.6

EINECS

220-359-9

Beilstein/Gmelin

1743977

Beilstein Reference

4-02-00-00952

Physical and Chemical Properties

Appearance

Colorless liquid. With a stench.

Solubility in water

Insoluble

Boiling Point

138

Density

0.9992 g/cm3 (0 C)

Vapor Density

4.64

Refractive Index

1.4234 (20 C)

First Aid Measures

Ingestion

Do NOT induce vomiting. If victim is conscious and alert, give 2-4 cupfuls of milk or water. Get medical aid immediately.

Inhalation

Get medical aid immediately. Remove from exposure to fresh air immediately. If not breathing, give artificial respiration. If breathing is difficult, give oxygen. DO NOT use mouth-to-mouth respiration. If breathing has ceased apply artificial respiration using oxygen and a suitable mechanical device such as a bag and a mask.

Skin

Get medical aid immediately. Immediately flush skin with plenty of soap and water for at least 15 minutes while removing contaminated clothing and shoes. Wash clothing before reuse. Destroy contaminated shoes.

Eyes

Get medical aid immediately. Do NOT allow victim to rub or keep eyes closed. Extensive irrigation is required (at least 30 minutes).

Handling and Storage

Storage

Keep away from heat, sparks, and flame. Keep away from sources of ignition. Keep container closed when not in use. Flammables-area. Storage under a nitrogen blanket has been recommended.

Handling

Wash thoroughly after handling. Remove contaminated clothing and wash before reuse. Ground and bond containers when transferring material. Use spark-proof tools and explosion proof equipment. Avoid contact with eyes, skin, and clothing. Empty containers retain product residue, (liquid and/or vapor), and can be dangerous. Keep container tightly closed. Avoid contact with heat, sparks and flame. Avoid ingestion and inhalation. Use with adequate ventilation. Discard contaminated shoes. Do not pressurize, cut, weld, braze, solder, drill, grind, or expose empty containers to heat, sparks or open flames.

Hazards Identification

Inhalation

Causes chemical burns to the respiratory tract. Aspiration may lead to pulmonary edema. Vapors may cause dizziness or suffocation. May cause systemic effects. May cause burning sensation in the chest.

Skin

Causes skin burns. May cause cyanosis of the extremities. May cause skin rash (in milder cases), and cold and clammy skin with cyanosis or pale color.

Eyes

Causes eye burns. Lachrymator. May cause chemical conjunctivitis and corneal damage.

Ingestion

May cause severe and permanent damage to the digestive tract. Causes gastrointestinal tract burns. May cause perforation of the digestive tract. Ingestion of large amounts may cause CNS depression. May cause systemic effects.

Hazards

Vapors may form explosive mixtures with air. Vapors may travel to source of ignition and flash back. Most vapors are heavier than air. They will spread along ground and collect in low or confined areas (sewers, basements, tanks). Vapor explosion hazard indoors, outdoors or in sewers.

UN (DOT)

1993

Exposure Controls/Personal Protection

Personal Protection

Eyes: Wear appropriate protective eyeglasses or chemical safety goggles as described by OSHA's eye and face protection regulations in 29 CFR 1910.133 or European Standard EN166. Skin: Wear appropriate protective gloves to prevent skin exposure. Clothing: Wear appropriate protective clothing to minimize contact with skin.

Respirators

A respiratory protection program that meets OSHA's 29 CFR 1910.134 and ANSI Z88.2 requirements or European Standard EN 149 must be followed whenever workplace conditions warrant a respirator's use.

Exposure Effects

Effects may be delayed.

Fire Fighting Measures

Flash Point

33

Fire Fighting

Wear a self-contained breathing apparatus in pressure-demand, MSHA/NIOSH (approved or equivalent), and full protective gear. During a fire, irritating and highly toxic gases may be generated by thermal decomposition or combustion. Will burn if involved in a fire. Use water spray to keep fire-exposed containers cool. Water may be ineffective. Material is lighter than water and a fire may be spread by the use of water. Containers may explode in the heat of a fire. Extinguishing media: For small fires, use dry chemical, carbon dioxide, water spray or alcohol-resistant foam. For large fires, use water spray, fog, or alcohol-resistant foam. Use water spray to cool fire-exposed containers. Water may be ineffective. Do NOT use straight streams of water.

Fire Potential

HIGHLY FLAMMABLE: Will be easily ignited by heat, sparks or flames.

Accidental Release Measures

Small spills/leaks

Absorb spill with inert material, (e.g., dry sand or earth), then place into a chemical waste container. Avoid runoff into storm sewers and ditches which lead to waterways. Clean up spills immediately, using the appropriate protective equipment. Remove all sources of ignition. Use a spark-proof tool. Provide ventilation. A vapor suppressing foam may be used to reduce vapors.

Stability and Reactivity

Incompatibilities

Alcohols, oxidizing agents, strong bases.

Stability

Stable under normal temperatures and pressures.

Decomposition

Hydrogen chloride, carbon monoxide, oxides of phosphorus, irritating and toxic fumes and gases, carbon dioxide, phosgene gas.

Combustion Products

Fire may produce irritating, corrosive and/or toxic gases.

Transport Information

UN Number

1993

Hazard Class

3

Packing Group

I; II; III