Solvent Blue 97 Property

Boiling point:

641.1±55.0 °C(Predicted)

Density 

1.166

vapor pressure 

0Pa at 25℃

pka

-0.41±0.20(Predicted)

Water Solubility 

20μg/L at 20℃

LogP

8.6 at 25℃

EPA Substance Registry System

9,10-Anthracenedione, 1,4-bis[(2,6-diethyl-4-methylphenyl)amino]- (32724-62-2)

Hazard and Precautionary Statements (GHS)

Symbol(GHS)

Signal word

Warning

Hazard statements

H317May cause an allergic skin reaction

H341Suspected of causing genetic defects

Precautionary statements

P201Obtain special instructions before use.

P202Do not handle until all safety precautions have been read and understood.

P261Avoid breathing dust/fume/gas/mist/vapours/spray.

P272Contaminated work clothing should not be allowed out of the workplace.

P280Wear protective gloves/protective clothing/eye protection/face protection.

P281Use personal protective equipment as required.

P302+P352IF ON SKIN: wash with plenty of soap and water.

P308+P313IF exposed or concerned: Get medical advice/attention.

P321Specific treatment (see … on this label).

P333+P313IF SKIN irritation or rash occurs: Get medical advice/attention.

P363Wash contaminated clothing before reuse.

P405Store locked up.

P501Dispose of contents/container to..…

Solvent Blue 97 Chemical Properties,Usage,Production

Description

Solvent Blue 97 is an anthraquinone blue chromogenic dye. It is a solvent soluble dye for plastics with high heat stability, good lightfastness and weather resistance, high color strength and outstanding brilliance.

Uses

Solvent Blue 97 is a blue solvent dye. It has good heat resistance and light fastness, good migration resistance and high tinting strength with wide application. Highly recommended for polyester fiber PET fiber, also allowed to be use for PA6 fiber. It is widely used in PS PET PA PC ABS (polyolefin, polyester, polycabonate, plastics).

Flammability and Explosibility

Non flammable

Synthesis

20.35 g of quinizarin, 20.38 g of dihydroquinizarin (contains 0.47 g of quinizarin), 10.8 g of trimethyl borate and 8.71 g of 90% by weight lactic acid were introduced into 159.7 g of 2,6-diethyl-4-methylaniline under nitrogen. The mixture was heated to 115?? C. over 1 h, in the course of which the resulting methanol was distilled off. Without delay, the temperature was then raised to 145?? C. over 2.5 h, and the mixture was stirred at 145?? C. for 8 h, during which resulting water was distilled off. Completeness of reaction was checked via a thin layer chromatogram. The mixture was then cooled down to 125?? C. and air was passed into it for 3 h. After cooling to 80?? C., 20.6 g of potassium hydroxide powder were added and air was again passed into it at 80?? C. for 4 h. 290 ml of methanol were added dropwise in the course of 2 h at 70?? C., followed by 1 h of stirring under gentle boiling. Finally, the suspension was cooled down to room temperature, filtered off with suction, washed with 200 ml of cold methanol and then with 11 of hot water (at 80?? C.) in portions. Vacuum drying at 80?? C. left 72.9 g (82.0% of theory) of a blue crystalline powder of the formula Heating time: 3.5 h Condensation time: 8 h