Product Identification

Product Name

2-Fluorophenol

Synonyms

1-Fluoro-2-hydroxybenzene
o-Fluorophenol
Phenol, 2-fluoro-

CAS

367-12-4

Formula

C6H5FO

Molecular Weight

112.1

EINECS

206-681-2

RTECS

SL4530000

RTECS Class

Other

Beilstein/Gmelin

1905112

Beilstein Reference

4-06-00-00770

EC Class

irritant

Physical and Chemical Properties

Appearance

Clear, yellow liquid.

Solubility in water

Slightly soluble

Melting Point

16

Boiling Point

151

Density

1.2172 g/cm3 (16 C)

pKa/pKb

8.71 (pKa)

Refractive Index

1.5112 (15.8 C)

First Aid Measures

Ingestion

not available, a glass of milk, or beaten egg whites and IMMEDIATELY transport victim to a hospital. If the victim is convulsing or unconscious, do not give anything by mouth, assure that the victim's airway is open and lay the victim on his/her side with the head lower than the body. DO NOT INDUCE VOMITING. IMMEDIATELY transport the victim to a hospital.

Inhalation

IMMEDIATELY leave the contaminated area; take deep breaths of fresh air. If symptoms (such as wheezing, coughing, shortness of breath, or burning in the mouth, throat, or chest) develop, call a physician and be prepared to transport the victim to a hospital. Provide proper respiratory protection to rescuers entering an unknown atmosphere. Whenever possible, Self-Contained Breathing Apparatus (SCBA) should be used.

Skin

IMMEDIATELY flood affected skin with water while removing and isolating all contaminated clothing. Gently wash all affected skin areas thoroughly with soap and water. IMMEDIATELY call a hospital or poison control center even if no symptoms (such as redness or irritation) develop. IMMEDIATELY transport the victim to a hospital for treatment after washing the affected areas.

Eyes

First check the victim for contact lenses and remove if present. Flush victim's eyes with water or normal saline solution for 20 to 30 minutes while simultaneously calling a hospital or poison control center. Do not put any ointments, oils, or medication in the victim's eyes without specific instructions from a physician. IMMEDIATELY transport the victim after flushing eyes to a hospital even if no symptoms (such as redness or irritation) develop.

Handling and Storage

Storage

Store in a flammables-area.

Handling

All chemicals should be considered hazardous. Avoid direct physical contact. Use appropriate, approved safety equipment. Untrained individuals should not handle this chemical or its container. Handling should occur in a chemical fume hood.

Hazards Identification

Inhalation

Vapors may cause dizziness or suffocation. May cause irritation or burns.

Skin

May cause irritation or burns.

Eyes

See Skin.

Hazards

Vapors may form explosive mixtures with air. Vapors may travel to source of ignition and flash back. Most vapors are heavier than air. They will spread along ground and collect in low or confined areas (sewers, basements, tanks). Vapor explosion hazard indoors, outdoors or in sewers.

EC Risk Phrase

R 10 21/22 34

EC Safety Phrase

S 26 36/37/39 45

UN (DOT)

1993

Exposure Controls/Personal Protection

Personal Protection

If Tyvek-type disposable protective clothing is not worn during handling of this chemical, wear disposable Tyvek-type sleeves taped to your gloves.

Respirators

Wear a NIOSH-approved half face respirator equipped with an organic vapor/acid gas cartridge (specific for organic vapors, HCl, acid gas and SO2) with a dust/mist filter.

Exposure Effects

The toxological properties of this substance have not been fully investigated.

Fire Fighting Measures

Flash Point

46

Fire Fighting

This compound is not very flammable but any fire involving this compound may produce dangerous vapors. You should evacuate the area. All firefighters should wear full-body protective clothing and use self-contained breathing apparatuses. You should extinguish any fires involving this chemical with a dry chemical, carbon dioxide, foam, or halon extinguisher.

Fire Potential

HIGHLY FLAMMABLE: Will be easily ignited by heat, sparks or flames.

Accidental Release Measures

Small spills/leaks

Should a spill occur while you are handling this chemical, you should dampen the solid spill material with alcohol, then transfer the dampened material to a suitable container. Use absorbent paper dampened with alcohol to pick up any remaining material. Seal the absorbent paper, and any of your clothes, which may be contaminated, in a vapor-tight plastic bag for eventual disposal. Solvent wash all contaminated surfaces with alcohol followed by washing with a strong soap and water solution. Do not reenter the contaminate area until the Safety Officer (or other responsible person) has verified that the area has been properly cleaned.

Stability and Reactivity

Disposal Code

2

Stability

Stable under normal temperatures and pressures.

Decomposition

Will form the following upon decomposition: carbon monoxide, carbon dioxide, hydrogen fluoride.

Combustion Products

Fire may produce irritating, corrosive and/or toxic gases.

Transport Information

UN Number

1993

Hazard Class

3

Packing Group

I; II; III

HS Code

2908 10 00