Hexafluoroacetone Property

Melting point:

−129 °C(lit.)

Boiling point:

−26 °C(lit.)

Density 

1,32 g/cm³

vapor density 

1.65 (vs air)

vapor pressure 

4525 mm Hg ( 21.1 °C)

storage temp. 

Refrigerator

solubility 

Chloroform

form 

Colorless gas, which reacts vigorously with water to form hydrates

CAS DataBase Reference

684-16-2(CAS DataBase Reference)

NIST Chemistry Reference

2-Propanone, 1,1,1,3,3,3-hexafluoro-(684-16-2)

EPA Substance Registry System

Hexafluoroacetone (684-16-2)

Safety

Hazard Codes 

T

Risk Statements 

60-14-23/24/25-34-63

Safety Statements 

53-26-28-36-45-7/9

RIDADR 

UN 2420 2.3

OEB

C

OEL

TWA: 0.1 ppm (0.7 mg/m3) [skin]

WGK Germany 

3

RTECS 

UC2450000

Hazard Note 

Highly Toxic

TSCA 

T

HazardClass 

2.3

Hazardous Substances Data

684-16-2(Hazardous Substances Data)

Toxicity

LD50 (mg/kg) in rats: 190 orally (trihydrate), 670 dermally (sesquihydrate); in mice: 250 i.p., 180 i.v.; in rabbits: 113 dermally (trihydrate) (Kennedy)

IDLA

9 ppm (61 mg/m3)

Hazard and Precautionary Statements (GHS)

Symbol(GHS)

Signal word

Danger

Hazard statements

H280Contains gas under pressure; may explode if heated

H314Causes severe skin burns and eye damage

H330Fatal if inhaled

Precautionary statements

P260Do not breathe dust/fume/gas/mist/vapours/spray.

P264Wash hands thoroughly after handling.

P264Wash skin thouroughly after handling.

P271Use only outdoors or in a well-ventilated area.

P280Wear protective gloves/protective clothing/eye protection/face protection.

P284Wear respiratory protection.

P301+P330+P331IF SWALLOWED: Rinse mouth. Do NOT induce vomiting.

P303+P361+P353IF ON SKIN (or hair): Remove/Take off Immediately all contaminated clothing. Rinse SKIN with water/shower.

P304+P340IF INHALED: Remove victim to fresh air and Keep at rest in a position comfortable for breathing.

P305+P351+P338IF IN EYES: Rinse cautiously with water for several minutes. Remove contact lenses, if present and easy to do. Continuerinsing.

P310Immediately call a POISON CENTER or doctor/physician.

P320Specific treatment is urgent (see … on this label).

P321Specific treatment (see … on this label).

P363Wash contaminated clothing before reuse.

P403+P233Store in a well-ventilated place. Keep container tightly closed.

P405Store locked up.

P410+P403Protect from sunlight. Store in a well-ventilated place.

P501Dispose of contents/container to..…

Hexafluoroacetone Chemical Properties,Usage,Production

Description

Hexafluoroacetone is a colorless, nonflammablepoison gas. Musty odor. Shipped as a liquefied compressedgas. .Molecular weight= 163.00; Boiling point =- 28to - 26℃; FreezingMelting point= - 122℃; Relative vapordensity (air= 1)= 5.76; Vapor pressure = 5.8 atm at 25℃.Hazard Identification (based on NFPA-704 M Rating System):Health 3, Flammability 0, Reactivity 0. Reacts with water.

Chemical Properties

generally supplied as liquid under pressure

Chemical Properties

Hexafluoroacetone is a colorless, nonflamma ble poison gas. Musty odor. Shipped as a liquefied com pressed gas.

Uses

In the synthesis of polymer, pharmaceutical, and agricultural chemicals; solvent for polyamides, polyesters, and polyacetals; in the synthesis of hexafluoroisopropanol

Uses

Hexafluoroacetone is a protecting and activatng reagent used in the synthesis of (S)-isoserine from (S)-malic acid. It is also an intermediate used to prepare hexafluorocarbinols as liver X receptor-α agonists.

Uses

Protecting and activating reagent in peptide chemistry; in synthesis of high performance fluoropolymers, pharmaceutical and agricultural chemicals; in 19F NMR. Solvent for polyamides, polyesters, polyacetals, polyols.

Definition

ChEBI: A ketone that is acetone in which all the methyl hydrogens are replaced by fluoro groups.

Synthesis Reference(s)

Canadian Journal of Chemistry, 33, p. 453, 1955 DOI: 10.1139/v55-055
Organic Syntheses, Coll. Vol. 7, p. 251, 1990

General Description

Hexafluoroacetone is a colorless, toxic, and highly reactive gas. At ambient temperatures, Hexafluoroacetone is likely to generate a considerable amount of vapor. Hexafluoroacetone is an irritant to skin, eyes and mucous membranes and is toxic by ingestion, skin absorption, and inhalation. When heated to high temperatures Hexafluoroacetone emits toxic fluoride fumes. Prolonged exposure of the container to fire or intense heat may cause Hexafluoroacetone to violently rupture and rocket. Hexafluoroacetone is used in the production of other chemicals.

Air & Water Reactions

Hygroscopic (i.e., absorbs moisture from the air); reacts with moisture to form a highly acidic sesquihydrate. .

Reactivity Profile

Hexafluoroacetone is incompatible with the following: Water, acids [Note: Hygroscopic (i.e., absorbs moisture from the air); reacts with moisture to form a highly acidic sesquihydrate.] .

Hazard

Toxic by inhalation and skin absorption. Reacts vigorously with water and other substances, releasing considerable heat. Nonflammable.

Health Hazard

TOXIC; may be fatal if inhaled, ingested or absorbed through skin. Vapors are extremely irritating and corrosive. Contact with gas or liquefied gas may cause burns, severe injury and/or frostbite. Fire will produce irritating, corrosive and/or toxic gases. Runoff from fire control may cause pollution.

Fire Hazard

Some may burn but none ignite readily. Vapors from liquefied gas are initially heavier than air and spread along ground. Some of these materials may react violently with water. Cylinders exposed to fire may vent and release toxic and/or corrosive gas through pressure relief devices. Containers may explode when heated. Ruptured cylinders may rocket.

Potential Exposure

Hexafluoroacetone is used as a chemi cal intermediate. A gas at room temperature, it forms vari ous hydrates with water which are used as solvents for resins and polymers. Other derivatives are used to make water repellent coatings for textiles and also to produce polymers.

First aid

If this chemical gets into the eyes, remove anycontact lenses at once and irri gate immediately for at least15 min, occasionally lifting upper and lower lids. Seekmedical attention immediately. If this chemical contacts theskin, remove contaminated clothing and wash immediatelywith soap and water. Seek medical attention immediately. Ifthis chemical has been inhaled,remove from exposure,begin rescue breathing (using universal precautions, includ-ing resuscitation mask) if breathing has stopped and CPR ifheart action has stopped. Transfer promptly to a medicalfacility. When this chemical has been swallowed, get medi-cal attention. Give large quantities of water and inducevomiting. Do not make an unconscious person vomit.Medical observation is recommended for 24- -48 h afterbreathing overexposure， as pulmonary edemamay bedelayed. As first aid for pulmonary edema, a doctor orauthorized paramedic may consider administering a cortico-steroid spray. If frostbite has occurred, seek medical atten-tion immediately; do NOT rub the affected areas or flushthem with water. In order to prevent further tissue damage,do NOT attempt to remove frozen clothing from frostbittenareas. If frostbite has NOT occurred, immediately andthoroughly wash contaminated skin with soap and water.

storage

(1) Color Code- White stripe: Contact Hazard;Store separately; not compatible with materials in solidwhite category. (2) Color Code- Blue (poison gas): HealthHazard/Poison: Store in a secure poison location. Prior toworking with this chemical youshould be trained on itsproper handling and storage. Store in tightly closed contain-ers in a cool, well-ventilatedarea away from direct sunlight,water，heat, reducing agents， nitrates, and nitric acid.Procedures for the handling, use, and storage of cylindersshould be in compliance with OSHA 1910.101and1910.169, as with the recommendations of the CompressedGas A ssociation.

Shipping

UN2420 Hexafluoroacetone, Hazard Class: 2.3; Labels: 2.3-Poisonous gas, 8-Corrosive material, Inhalation Hazard Zone B. Cylinders must be transported in a secure upright position, in a well-ventilated truck. Protect cylinder and labels from physical damage. The owner of the com pressed gas cylinder is the only entity allowed by federal law (49CFR) to transport and refill them. It is a violation of transportation regulations to refill compressed gas cylin ders without the express written permission of the owner.

Purification Methods

Dehydrate hexafluoroacetone by passing the vapours over P2O5. Ethylene is removed by passing the dried vapours through a tube containing Pyrex glass wool moistened with conc H2SO4. Further purification is by low temperature distillation using Warde-Le Roy stills. Store it in the dark at -78o. [Holmes & Kutschke Trans Faraday Soc 58 333 1962, Beilstein 1 IV 3215.]

Incompatibilities

Reacts with water, oxidizers, strong acids. Hygroscopic (i.e., absorbs moisture from the air); reacts with moisture to form a highly acidic sesquihydrate and considerable heat.

Waste Disposal

Return refillable compressed gas cylinders to supplier. Nonrefillable cylinders should be disposed of in accordance with local, state and federal regulations. Allow remaining gas to vent slowly into atmosphere in an unconfined area or exhaust hood. Refillable-type cylinders should be returned to original sup plier with any valve caps and outlet plugs secured and valve protection caps in place.